Huawei AP4050DN Hardware Installation And Maintenance Manual page 64

AP4050DN-HD
Hardware Installation and Maintenance Guide
Figure 5-49 Feeding the terminal into the jack



Step 3 Move the cable slightly and ensure that it is securely connected.
Step 4 Before you remove a cord end terminal, loosen the screw counterclockwise.
----End
Installing Ethernet Adapters
Installing a Shielded Ethernet Connector
Procedure
Step 1 Hold the male and female connectors, with the male connector facing the female connector, as
shown in Figure 5-50.
Figure 5-50 Holding the male and female shielded connectors
Step 2 Insert the male connector into the female connector, as shown in Figure 5-51.
Issue 01 (2016-04-15)
Ensure that the exposed section of the terminal is less than 2 mm (0.079 in.) in length.
Do not press the insulation of the terminal.
Insert only one terminal into one jack.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Appendix
58