Logging In To The Device; Logging In To The Device Using Stelnet/Telnet - Huawei AP4050DN Hardware Installation And Maintenance Manual

AP4050DN-HD
Hardware Installation and Maintenance Guide
About This Chapter

3.1 Logging In to the Device Using STelnet/Telnet

3.2 Logging In to the Device Through the Console Port
3.1 Logging In to the Device Using STelnet/Telnet
You can log in to the device using STelnet V2 or Telnet to configure, manage, and maintain
the device in the CLI.
Before logging in to the device, complete the following tasks:


The following table lists the default configuration of the device. You are advised to change the
default user name and password on your first login.
Table 3-1 Default configuration of the device
Parameter
User name
Password
IP address
Subnet mask
Issue 01 (2016-04-15)
3
By default, only the STelnet V2 service is enabled on the device.

Telnet has security vulnerabilities. You are not advised to enable the Telnet service.

Power on the device.
Prepare network cables used to connect device interfaces.
If the device is already online on the AC, you can remotely log in to the AC on a local terminal and run
the display ap all command to check the IP address of the device.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Logging In to the Device

Default Setting
admin
admin@huawei.com
169.254.1.1
255.255.0.0
3 Logging In to the Device
24