Huawei AP4050DN Hardware Installation And Maintenance Manual page 21

AP4050DN-HD
Hardware Installation and Maintenance Guide
3. Hang the AP on the mounting holes by aligning the mounting screws at the rear of the
AP with the mounting holes on the bracket and push the AP horizontally to secure the
AP.
Angle-Adjustable Mounting Bracket
1. Remove a ceiling tile and determine locations of mounting holes based on the distance
between two installation holes on the mounting bracket. Use a hammer drill to drill holes
on the ceiling tile and fasten a base bracket with the ceiling tile (with a tightening torque
of 3 N•m).
The screws provided for ceiling mounting of APs are 30 mm long and can be used to fix
an AP on a ceiling no thicker than 15 mm. To install APs on thicker ceilings, you need to
purchase longer screws.
1. Ceiling tile
2. Remove the topmost screw from the base bracket, hang the AP-side mounting bracket
onto the topmost screw, and tighten the screw until the screw passes through the hole of
the horizontal scale plate.
Issue 01 (2016-04-15)
2. U-shaped mounting bar
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 AP Installation
3. M6x35 screw
15