Installing Optional Idsdm Module - Dell EMC PowerEdge R940 Installation And Service Manual

Figure 91. Removing the optional IDSDM module
NOTE: There are two dip switches on the IDSDM module for write-protection.
Next steps
Install the optional IDSDM module.

Installing optional IDSDM module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the IDSDM module on the system board.
To locate IDSDM module, see the
2. Align the IDSDM module with the connector on the system board.
3. Push the IDSDM module until it is firmly seated on the system board.
Safety instructions
Before working inside your system
System board jumpers and connectors
on page 29.
on page 30.
section.
Installing and removing system components 107