Figure 88. Installing the storage controller card
Next steps
1.
Install the NDC
riser.
2. Follow the procedure listed in
Optional IDSDM or vFlash module
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Locate the MicroSD card slot on the IDSDM module, and press the card to partially release it from the slot. To locate IDSDM
module, see the
System board jumpers and connectors
2. Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
104
Installing and removing system components
After working inside your system
Safety instructions
Before working inside your system
on page 30.
on page 29.
on page 30.
section.