Installing The Expansion Card Riser - Dell EMC PowerEdge R940 Installation And Service Manual

Installing the expansion card riser

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
Steps
1. Align the guide rail on the side of the riser with the slot on the side of the chassis and lower the riser into the system.
2. Lower the release lever until the connector on the riser connects with the connector on the processor expansion module
(PEM).
CAUTION: To avoid damage to the connectors on the PEM, you must only use the release levers to seat the
expansion card risers firmly on the PEM.
Figure 77. Installing expansion card riser (right)
Safety instructions
Before working inside your system
on page 29.
on page 30.
Installing and removing system components 93