Figure 67. Removing the PEM
Next steps
Install the
PEM.
Installing the PEM
Prerequisites
1. Follow the safety guidelines listed in
Safety instructions
on page 29.
2. Follow the procedure listed in
Before working inside your system
on page 30.
Steps
1. Hold the PEM using the handle and align the slots on the sides of the PEM with the standoffs on the sides of the system.
2. Lower the PEM until it clicks into place.
3. Re-connect the cables to the PEM. For information about cable routing, see the section
UPI cable routing
on page 84.
4. Hold the PEM handle and lower the PEM until it firmly seats in place.
82
Installing and removing system components