Figure 37. Installing an intrusion switch
Next steps
1. Lift the sides of the fan tray until the blue release tabs click in place.
2.
Install the
PEM.
3. If removed,
install the expansion card
4.
Install the air
shroud.
5.
Install the fan
cage.
6. Follow the procedure listed in
Drives
Removing a drive blank
Prerequisites
1. Follow the safety guidelines listed in
2. If installed,
remove the front bezel.
CAUTION:
To maintain proper system cooling, drive blanks must be installed in all empty drive slots.
CAUTION:
Mixing drive blanks from previous generations of PowerEdge servers is not supported.
Steps
Press the release button, and slide the drive blank out of the drive slot.
48
Installing and removing system components
risers.
After working inside your system
Safety instructions
on page 30.
on page 29.