Cooling Fan Replacement - Polaris RZR PRO XP 2020 Service Manual

Hide thumbs Also See for RZR PRO XP 2020:

Table of Contents

FAN CONTROL CIRCUIT BYPASS TEST

1. Disconnect

sensor on the engine cylinder head (see Engine

outlined in this chapter).

2. With the transmission in Park, start the engine. After

a few seconds, the fan should start running and the

"Check Engine" indicator should display on the

components are working properly.

3. If the fan does not run or runs slowly, check the fan

motor wiring, ground, motor condition, circuit breaker

and mechanical relay for proper operation. Repair or

replace as necessary. If the fan runs with the sensor

harness disconnected, but will not turn on when the

engine is hot, check the coolant temperature sensor

and connector terminals.

9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual

COOLING FAN REPLACEMENT

1. Remove front fascia. See Front Fascia Removal page

2. Drain cooling system.

3. Remove four electrical connectors from the voltage

4. Remove two fasteners

securing voltage regulator

bracket and remove bracket/voltage regulators as an

5. Remove six push pins

and remove the radiator

6. Remove two large hoses and one vent line from the

charge air radiator and remove charge air radiator

from the vehicle.

Table of Contents