Polaris RZR PRO XP 2020 Service Manual page 231

o
14. Install the eleven M6 and two M8
crankcase bolts. Tighten all bolts lightly by hand.
15. Torque the upper crankcase bolts in sequence to
specification. Repeat the sequence to verify final
torque.
TORQUE
Upper Crankcase Bolts:
M8 Bolts:
26 ft-lb (35 Nm)
M6 Bolts:
9 ft-lb (12 Nm)
16. Rotate the engine so the cylinder is facing down.
17. Install a new seal on the oil pump.
18. Lift the oil pump drive chain and install the oil pump.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
© Copyright Polaris Industries Inc.
i
upper 19. Install dowel pins
20. Install the three bolts
crankcase. Torque mounting bolts to specification.
21. Reinstall oil pump pick-up
g
to specification.
22. Clean the gasket sealing surfaces on oil sump cover
and crankcase to remove old gasket material and any
oil.
Gasket surfaces must be DRY and oil free. Use care
ENGINE / COOLING SYSTEM
s
into oil pump mounting holes.
d
that retain oil pump to the
TORQUE
Oil Pump Mounting Bolts:
7 ft-lbs (10 Nm)
f
. Torque mounting screw
TORQUE
Oil Pump Pick-Up Retaining Screw:
7 ft-lb (10 Nm)
NOTICE
upon assembly to keep oil away.
3
3.87