Polaris RZR PRO XP 2020 Service Manual page 448

STEERING / SUSPENSION
31. Remove negative spring assembly, bearing
assembly, and bumper.
32. With the shaft assembly placed in clamp block and
secured in vise, apply a sufficient amount of heat to
the eyelet with a propane torch to remove the eyelet
with the correct body cap socket.
33. Use a wire brush, heat, and a pick to remove any
Loctite residue left in the eyelet and shaft threads.
Clean thoroughly with contact cleaner and lint-free
towel.
9.44
34. Apply Loctite primer 7649 to eyelet threads
over-spray off any external surface.
35. Remove all seals and o-rings from bearing assembly.
NOTICE
If the DU bearing needs replacement, replace the
complete bearing assembly.
36. Clean all surfaces of the bearing housing and cinch
ring.
9850068 R01 - 2020-2021 RZR PRO XP / XP 4 Service Manual
q
. Wipe
© Copyright Polaris Industries Inc.