Table of Contents
Advertisement
1-10. Installation Procedure
6. Loosen the rock screw, then insert the control panel.
9. Installation of the OPS assembly
1. Pull the OPS cover toward you, then remove from the base plate.
2. Pass the reference pins through the holes on the OPS assembly, then fix it with the supplied four
screws (M3 x 6) .
3. Connect the connector of the base plate with CN1 on the SE-515 board.
4. Adjust the hole at the rear of the OPS cover to the OPS support, push in the OPS support completely,
and install to the base plate.
Reference pins
OPS support
1-16
Control panel
Base plate
Reference pins
OPS support
CN1
Connector
SE-515 board
OPS assembly
OPS cover
PSW3 x 6
PSW3 x 6
FVS-1000 MMP1
Advertisement
Table of Contents
