Sony FVS-1000 Maintenance Manual page 113

35T Pad Assembly
Removal
1. Removing the pad assembly
Rotate the two screws of the A portion with your
fingers in the counterclockwise direction, and
remove the 35T pad assembly.
Installation
2. Installing the pad assembly
(1) Align the reference hole and long hole of the
35T pad assembly and the pad positioning
shaft.
n
At this time, check that the pad drive pin
enters the slot of the pad arm.
(2) Press the 35T pad assembly against the base
plate, rotate the two screws of the A portion
with your fingers in the counterclockwise
direction, and install.
FVS-1000 MMP1
Pad positioning shaft
Slot
A
A
Reference hole
35T pad assembly
4-2. Replacing the Pad Assembly
Pad driving pins
Pad arms
Pad positioning shaft
4-3