Chapter 2 Preparation; Wiring; Inserting Sd Memory Cards - Mitsubishi Electric MELSEC iQ-R Series Introduction Manual

2
PREPARATION
2.1

Wiring

The following shows the wiring described in this document.
Connect the personal computer, CPU module, camera recorder module, network camera, MI3000, and GOT to the PoE
switching hub using the Ethernet cable.
GOT
MI3000
Set the IP addresses for the programmable controller, network camera, MI3000, personal computer for
setting, and GOT. The IP addresses must be set with the same segment.
2.2

Inserting SD Memory Cards

Insert SD memory cards into the CPU module, camera recorder module, and GOT.
Although an SD memory card is not required for the CPU module, it is recommended to be used.If the event logging is saved
in ROM, the CPU life will be shortened due to the limited number of write cycles.
An SD memory card is required to save recording files.
CPU module
*1 An SD memory card is not required to be inserted when data is saved to the file server.
Programmable controller
PoE
switching hub
Personal computer
Network camera
*1
for setting
Camera recorder module
2
2 PREPARATION
6
2.1 Wiring