Toro LT-F3000 Installation Instructions Manual page 9

Connecting the Wire Harness to
the Differential-Lock Solenoid and
Parking-Brake Solenoid
1. At the top of the machine, plug the 2-pin
connector of the machine wire harness labeled
P B S into the parking-brake solenoid
RAKE OL
(Figure 22).
Figure 22
1. Front of the machine
2. Parking-brake solenoid
2. Remove the cap from the 2-pin connector of the
machine wire harness labeled D
(Figure 23).
g342834
g342985
3. 2-pin connector—machine
wire harness (labeled P
B S )
RAKE OL
L S
IFF OCK OL
1. 2-pin connector—machine
wire harness (labeled D
L S )
OCK OL
2. Cap
3. Plug the connector labeled D
the differential lock solenoid
Installing the Hoses at the Back of
the Front Transmission Manifold
Note:
Before you install the hoses, check that all
hose O-rings are undamaged and correctly installed.
Replace any damaged O-rings; remove realign any
incorrectly installed O-rings
1. Assemble the left traction-motor hose (marked
FAL) onto the straight fitting in port-FAL of the
front transmission manifold
9
Figure 23
3. Front of the machine
IFF
4. Differential lock solenoid
L S
IFF OCK
(Figure 23).
(Figure 24).
g342984
into
OL