Toro LT-F3000 Installation Instructions Manual page 12

Note:
Retain the pressure transducer for
installation in Installing the Brake Pressure
Transducer (page
Figure 31
1. Reducer fitting (3/4 x 7/16
inch)
3. Remove the reducer fitting (3/4 x 7/16 inch) from
port-MB of the traction pump
Figure 32
1. Port-MB (traction pump)
2. Reducer fitting (3/4 x 7/16
inch)
4. Install the straight fitting (3/8 x 3/4 inch) into
port-MB of the traction pump
5. Torque the straight fitting to 81 N∙m (60 ft-lb).
13).
2. Brake-pressure
transducer
(Figure 32).
3. Straight fitting (3/8 x 3/4
inch)
(Figure 32).
Installing the Pump Fitting
Machines without the Optional Road Light Kit
1. At the right side of the transmission pump,
remove the plug from port-MB of the traction
pump (Figure 33
g344080
1. Port-MB (traction pump)
g344907
2. Plug
2. Install the straight fitting (3/8 x 3/4 inch) into
port-MB of the traction pump
3. Torque the straight fitting to 81 N∙m (60 ft-lb).
12
and Figure 34).
Figure 33
Figure 34
3. Straight fitting (3/8 x 3/4
inch)
(Figure 34).
g343559
g343556