Figure 39
1. Port-PS (front traction
manifold)
3.
Assemble the adapter fitting (1/4 x 7/16 inch)
into port-PS of the front traction manifold
40) with a seal (1/4 inch).
Figure 40
1. Adapter fitting (1/4 x 7/16
inch)
2. Seal (1/4 inch)
4.
Torque the adapter fitting to 34 to 41 N∙m (25
to 30 ft-lb).
5.
Assemble the brake-pressure transducer into
the adapter fitting
6.
Torque the transducer to 20 N∙m (15 ft-lb).
7.
Plug the 3-pin connector labeled
PRESSURE SENSOR
transducer
(Figure
2. Hex-socket plug
3. Port-PS (front traction
manifold)
4. Brake-pressure
transducer
(Figure
40).
BRAKE
into the brake-pressure
41).
g344933
(Figure
1. Brake-pressure
transducer
6
Finishing the Kit Installation
No Parts Required
Checking the Hydraulic Fluid
Check the hydraulic fluid level in the tank—add
hydraulic fluid as needed; refer to Checking the
Hydraulic Fluid in the Operator's Manual for your
machine.
g344935
Connecting the Battery
1.
Assemble the terminal of the negative battery
cable
(Figure
14
Figure 41
2. 3-pin connector (labeled
BRAKE PRESSURE
—machine wire
SENSOR
harness)
42) onto the negative battery post.
g344934