Engine Maintenance; Accessing The Engine - Toro 25450 Operator's Manual

Figure 58
1. Grease fitting
3. Wipe up any excess grease.

Engine Maintenance

Before maintaining the engine, perform the following steps:
1. Park the machine on level ground, lower all
attachments, and stop the engine.
2. Remove the ignition key and allow the engine to cool
for 2 or 3 minutes.

Accessing the Engine

Removing the Side Panels
1. If the optional backhoe is installed, perform the
following substeps to remove the left side panel;
otherwise, skip to step 2:
A. At the left side of the machine, remove the
retaining pin from the front end of the walkway
(Figure 59).
1. Retaining pin
B. Pivot the walkway away from the machine as
shown in Figure
2. If the side panel is locked, insert the key for the
side-panel latches into the cylinder of the lock and
unlock the latch.
Note: The key for the side-panel latch is a different
key from the one use to start and run the machine.
3. Press in the button portion of each latch—the part of
the latch including the lock cylinder
45
Figure 59
2. Walkway
59.
(Figure 60).