Table of Contents
Advertisement
3. Look through the sight port and check that the oil level
in the axle is level with the bottom of the threads of
the port
(Figure 86
Note: Use a flashlight and a mirror to help you see
the oil level.
•
If the oil level is too high, allow the oil to drain
from the sight port.
•
If the oil level is too low, add the specified oil to
the axle housing sight port; refer to steps
Changing the Oil in the Axles (page
4. Clean the threads of the sight plug.
5. Apply PTFE thread sealing tape to the threads of the
plug.
6. Install the sight plug into the sight port in the pinion
housing of the axle
Changing the Oil in the Axles
Service Interval: After the first 200 hours
Every 1,000 hours
Front axle oil capacity: approximately 9 L (9.5 US qt)
Rear axle oil capacity: approximately 9 L (9.5 US qt)
Toro Premium Gear Oil is available from an Authorized Toro
Service Dealer. See the parts catalog for part numbers.
1. Place a drain pan under the pinion housing of the axle
(Figure 88
and
Figure
1. Drain plug
2. Drain pan
and
Figure
87).
60).
(Figure 86
and
Figure
87).
89).
Figure 88
Front Axle
3. Drain port
4. Front-axle housing
6
and
7
in
1. Drain plug
2. Drain pan
2. Remove the plugs from the sight port and the drain
port of the pinion housings for the axles
and
Figure
Note: Allow the oil to drain completely from the
pinion housing and axle.
3. Clean the threads of the plugs.
4. Apply PTFE thread sealing tape to the threads of the
plugs.
5. Install the drain plugs into the drain ports at the pinion
housings
60
Figure 89
Rear Axle
3. Drain port
4. Rear-axle housing
89).
(Figure 90
and
Figure
91).
(Figure 88
Advertisement
Table of Contents
