Adjusting The Auger Cable; Adjusting The Transmission Cable; Checking The Tire Pressure - Toro SnowMaster 724 QXE Operator's Manual

Adjusting the Auger Cable

Service Interval: After the first 2 hours
Yearly
If the drive belt slips or squeals under heavy load, adjust the
auger cable.
1. Loosen the nut on the lower cable clamp, but do not
remove it (Figure 23).
1. Nut
2. Cable
2. Pull the cable up to remove some slack
Important: Do not remove all the slack from
the cable. Removing all the slack from the cable
prevents the auger from stopping properly.
3. Hold the cable in place and tighten the nut
Figure 23
3. Connector
4. Spring
(Figure
(Figure
Adjusting the Transmission
Cable
Service Interval: After the first 2 hours
Yearly
If the wheels easily stall out, or if the wheels drive without
engaging the self-propel handle, adjust the transmission cable.
1. Loosen the nut on the upper cable clamp, but do not
remove it
1. Nut
23).
2. Pull the cable down to remove most of the slack in the
cable (Figure
Important: Do not remove all the slack from the
23).
cable. Removing all the slack from the cable may
cause the wheels to engage without engaging the
self-propel handle.
3. Tighten the nut

Checking the Tire Pressure

Service Interval: Yearly
Check the air pressure in the tires and inflate them to 103 to
137 kPa (15 to 20 psi).
17
(Figure 24).
Figure 24
2. Cable
24).
(Figure 24).