Table of Contents
Advertisement
Maintenance
Note: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Maintenance Service
Interval
Initially
Annually
Adjusting the Control Cable
Important: Check the control cable for proper
adjustment initially, after the first operating hour, and
then annually thereafter.
Checking the Cable
1. Move the control bar
back toward the handle
to remove the slack in
the cable.
2. Ensure that a 1/16
to 1/8 in. (2 to 3 mm)
gap (A) exists between
the control bar and the
handle. To adjust the
cable, refer to Adjusting
the Cable below.
Important: The control
cable must contain
some slack when you
disengage the control
bar for the rotor blades
to stop properly.
Maintenance Procedure
Check the control cable both initially and after the first hour of operation; adjust it
if necessary.
Check for loose fasteners and tighten them if necessary.
Check the control cable and adjust it if necessary.
Inspect the rotor blades and have an Authorized Service Dealer replace the rotor
blades and the scraper if necessary.
Have an Authorized Service Dealer inspect the spark plug and replace it if
necessary.
Have an Authorized Service Dealer inspect the drive belt and replace it if
necessary.
Store the snowthrower properly.
Check for loose fasteners and tighten them if necessary.
A
m-6198
3329-453
9
Advertisement
Table of Contents
