Inspecting The Throwing Edges; Changing The Engine Oil - Toro SnowMaster 724 QXE Operator's Manual

Inspecting the Throwing
Edges
Service Interval: Yearly—Inspect the throwing edges and
have an Authorized Service Dealer
replace the throwing edges and scraper
if necessary.
Before each session, inspect the throwing edges for wear.
When a throwing edge has worn down to the wear-indicator
hole, have an Authorized Service Dealer replace the throwing
edges ().
1. The wear-indicator hole
is intact; you do not need
to replace the throwing
edges.

Changing the Engine Oil

Service Interval: After the first 2 hours
Yearly
If possible, run the engine for a few seconds before changing
the oil because warm oil flows better and carries more
contaminants.
Use automotive detergent oil with an API service classification
of SJ, SL, or higher.
Use Figure 18 to select the best oil viscosity for the outdoor
temperature range expected:
Figure 17
2. The wear-indicator hole
is exposed; replace both
throwing edges.
Engine Oil Capacities
Model
36002
36003
1. Move the machine to a level surface.
2. Place an oil-drain pan under the oil-drain plug, remove
the oil-drain plug, and tip the machine backward and
drain the used oil in the oil-drain pan
1. Oil-drain plug
3. After draining the used oil, return the machine to the
operating position.
4. Install the oil-drain plug and tighten it securely.
5. Clean around the oil-fill cap.
6. Fill the crankcase with oil.
A. Remove the dipstick and slowly pour oil into the
oil-fill tube to raise the oil level to the Full mark
on the dipstick
15
Figure 18
Max Fill
0.5 L (16.9 oz)
0.7 L (23.7 oz)
(Figure
Figure 19
(Figure 20). Do not overfill.
19).