Shutting Off The Engine; Engaging The Auger; Disengaging The Auger - Toro SnowMaster 724 QXE Operator's Manual

Using the Electric Starter
Note: Prime the engine in B of
following table:
Temperature
-23°C (-10°F) and above
Below -23°C (-10°F)
To use the electric starter (electric start only), connect a power
cord to the electric-start plug-in first and then to a ground
Figure 11
Figure 12 according to the
Suggested Number of Primes
3
6
fault circuit interrupter (GFCI) power outlet. Use only a
UL-listed, 16-gauge power cord recommended for outdoor
use that is not longer than 15 m (50 ft).
Important: Do not use a worn or damaged power cord.
Important: To prevent damaging the electric starter,
run it in short cycles (5 seconds on, 5 seconds off), no
more than 10 times. If the engine still does not start, take
the machine to an Authorized Service Dealer for service.
WARNING
The electrical cord can become damaged, causing
a shock or fire.
Thoroughly inspect the electrical cord before using
the machine. If the cord is damaged, do not use it.
Replace or repair the damaged cord immediately.
Contact an Authorized Service Dealer for assistance.
CAUTION
If you leave the machine plugged into a power
source, someone can inadvertently start the
machine and injure people or damage property.
Unplug the power cord whenever you are not
starting the machine.

Shutting Off the Engine

To shut off the engine, remove the key from the ignition or
move the key to the middle position.

Engaging the Auger

Disengaging the Auger

To disengage the auger, release the auger lever.
10
Figure 12