Advertisement

Quick Links

CCRt 2450 GTS
Snowthrower
Model No. 38515—Serial No. 250000001 and Up
Introduction
Read this manual carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for
operating the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. The
illustration below identifies the location of the model
and serial numbers on the product. Write the numbers
in the space provided below:
Model #:
Serial #:
This manual identifies potential hazards and has
safety messages identified by the following words:
Danger signals an extreme hazard that will
cause serious injury or death if you do not follow
the recommended precautions.
Warning signals a hazard that may cause
serious injury or death if you do not follow the
recommended precautions.
Caution signals a hazard that may cause minor
or moderate injury if you do not follow the
recommended precautions.
This manual uses 2 words to highlight information.
Important: calls attention to special mechanical
information and Note: emphasizes general
information worthy of special attention.
Warning
The engine exhaust from this product contains
chemicals known to the State of California to
cause cancer, birth defects, or other reproductive
harm.
E 2004—The Toro Company
8111 Lyndale Ave., Bloomington, MN 55420, USA
)
Important: This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate this
engine on any forest-covered, brush-covered, or
grass-covered land. Other states or federal areas
may have similar laws.
Important: The 2-stroke engine provided on this
product meets the EPA Phase I Non-road Emissions
regulations for engines under 19 kW. This product
does not meet CARB TIER 1 regulations and cannot
be sold in California.
This spark ignition system complies with Canadian
ICES-002.
Safety
Read and understand the contents of this manual
before the engine is ever started.
This is the safety alert symbol. It is used to
alert you to potential personal injury hazards.
Obey all safety messages that follow this symbol
to avoid possible injury or death.
m 5515
Improperly using or maintaining this
snowthrower could result in injury or death. To
reduce this potential, comply with the following
safety instructions.
The following instructions have been adapted from
the ANSI/OPEI standard B71.3–1995 and the ISO
8437:1989 standard.
Training
Read the operator's manual carefully. Be
thoroughly familiar with the controls and the
proper use of the equipment. Know how to stop
the unit and disengage the controls quickly.
Never allow children to operate the snowthrower.
Never allow adults to operate the snowthrower
without proper instruction.
Keep the area of operation clear of all persons
(particularly small children) and pets.
Exercise caution to avoid slipping or falling.
Printed in the USA
All Rights Reserved
Form No. 3351-827 Rev A
Operator's Manual
Original Instructions (EN)
Register your product at www.Toro.com

Advertisement

Table of Contents
loading

Summary of Contents for Toro 38515

  • Page 1 Whenever you need service, genuine Toro parts, or additional information, contact an Authorized Service This spark ignition system complies with Canadian Dealer or Toro Customer Service and have the model ICES-002. and serial numbers of your product ready. The illustration below identifies the location of the model Safety and serial numbers on the product.
  • Page 2: Maintenance And Storage

    • Never attempt to make any adjustments while the attempting to clear snow at too fast a rate. engine is running, except where specifically recommended by Toro. Look behind and use care when backing up with • the snowthrower. •...
  • Page 3 Toro Snowthrower Safety The following list contains safety information specific to Toro products or other safety information that you must know. • Rotating rotor blades can injure fingers or hands. Stay behind the handles and away from the discharge opening while operating the snowthrower.
  • Page 4: Safety/Instruction Decals

    Safety/Instruction Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. 60-9480 104-2767 104-4135 104-2775 105-1978 3351-827 Rev A...
  • Page 5 Etats-Unis : d’après-vente aux Etats-Unis : 1-800-526-6937 1-800-526-6937 The Toro Company Canada: 1-866-854–9033 Bloomington, MN The Toro Company INFORMATION IMPORTANTE CONCERNANT LE MOTEUR Bloomington, MN INFORMATION IMPORTANTE CONCERNANT LE MOTEUR...
  • Page 6: Product Overview

    Product Overview Setup Unfolding the Handle 1. Cut the plastic tie that secures the control cable to the handle. Note: Hold the cable taut to ensure that it stays disconnected at the bottom. 2. Loosen the knobs, pull out the handle bolts, and rotate the upper handle to the operating position.
  • Page 7: Installing The Discharge Chute

    Installing the Discharge Mixing Gasoline and Oil Chute This snowthrower uses a 50:1 gasoline-to-oil mixture. Use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added) Install the discharge chute as shown. or an equivalent high-grade, NMMA TCW-certified two-cycle oil. Important: To prevent engine damage, do not use automotive oil (such as SAE 30 or 10W30) or fuel mixed at the wrong gasoline-to-oil ratio.
  • Page 8: Operation

    Operation Starting the Rotor Blades To start the rotor blades, hold the control bar against Note: Determine the left and right sides of the the handle. machine from the normal operating position. Starting the Engine 1. Turn the ignition key clockwise to the On position.
  • Page 9 Throwing Snow Warning The rotor blades can throw stones, toys, and other foreign objects and cause serious personal injury to the operator or to bystanders. Keep the area to be cleared free of all objects that the rotor blades could pick up and throw. Keep all children and pets away from the area of operation.
  • Page 10: Recommended Maintenance Schedule

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule Maintenance Service Maintenance Procedure Interval • Check the control cable both initially and after the first hour of operation; adjust it if necessary.
  • Page 11 Inspecting the Rotor Adjusting the Cable Blades 1. Unhook the end of the control cable from Before each season, inspect the rotor blades for the control bar. wear. When a rotor blade edge has worn down to the wear indicator hole (A), have an Authorized Service Dealer replace the rotor blades and the scraper.
  • Page 12: Folding The Handle

    This can damage the chute handle. 1. Add a fuel stabilizer/conditioner to the fuel in the fuel tank as directed. Note: If you use Toro 50:1 2-Cycle Oil (Fuel Stabilizer Added), you do not need to add a fuel stabilizer/conditioner.
  • Page 13 3351-827 Rev A...
  • Page 14 3351-827 Rev A...
  • Page 15 You are responsible for presenting your equipment engine to an Authorized Service Dealer as soon as a problem exists. The warranty repairs should be If you think that your Toro Product contains a defect in materials or completed in a reasonable amount of time, not to exceed thirty (30) days.
  • Page 16 Instructions for Obtaining Warranty Service If you think that your Toro Product contains a defect in materials or workmanship, or if a normal, able-bodied adult can no longer start your product’s engine in one or two pulls, follow this procedure: 1.

This manual is also suitable for:

Ccr 2450 gts

Table of Contents