Checking And Adjusting The Skids; Inspecting The Throwing Edges; Changing The Engine Oil - Toro 36002 Operator's Manual

Checking and Adjusting the
Skids
Service Interval: Yearly
Check the skids to ensure that the auger does not contact the
paved surface. Adjust the skids as needed to compensate for
wear (Figure 17).
1. Loosen the skid bolts.
2. Slide a 5 mm (3/16 inch) board underneath the scraper.
Note: Using a thinner board will result in a more
aggressive scraper. A thicker board will result in a less
aggressive scraper.
3. Lower the skids to the ground.
Note: Ensure the skids are flat on the ground.
4. Tighten the skid bolts.
1. 5 mm (3/16 inch) board
Figure 17
2. Ground
Inspecting the Throwing
Edges
Service Interval: Yearly—Inspect the throwing edges and
have an Authorized Service Dealer
replace the throwing edges and scraper
if necessary.
Before each session, inspect the throwing edges for wear.
When a throwing edge has worn down to the wear indicator
hole, have an Authorized Service Dealer replace the throwing
edges (Figure 18).
1. The wear indicator hole
is intact; you do not need
to replace the throwing
edges.

Changing the Engine Oil

Service Interval: After the first 2 hours
Yearly
Run the engine a few minutes before changing the oil to warm
it. Warm oil flows better and carries more contaminants.
1. Move the machine to a level surface.
2. Place an oil drain pan under the oil-drain plug, remove
the oil-drain plug, and tip the machine backward and
drain the used oil in the oil-drain pan
13
Figure 18
2. The wear indicator hole
is exposed; replace both
throwing edges.
(Figure 19).