Pannelling The Door; Prior To Initial Start-Up; Electrical Connection; Plug Socket - Blomberg KU 1160 Operating Instructions Manual

Flushline built-under refrigerator

Table of Contents

Slide the hole cover (L) off the ventilation grille and fit it on the

opposite side.

Pannelling the door

Take off the door frame section opposite to the door handle;

loosen, without removing them, all remaining screws securing the door

frame;

slide in the decor panel from the frameless side, then fasten again the

frame to the door including the previously removed frame section.

Note:

The overall dimensions of the decor panel must be 1 to 2 mm less than

those of the door, with a maximum thickness of 4 mm.

Prior to Initial Start–Up

Please clean the appliance interior and all accessories prior to initial start-up (see section: "Cleaning and

Care").

The plug socket necessary for con-nection of your appliance to the electricity supply should be positio-

ned so that it is possible to pull out the appliance plug.

If your appliance is installed under a continuous worktop, the plug socket should be provided as shown.

A concealed protective contact plug socket requires 10 A/16 A fusing.

If the socket is not accessible once the appliance is built in, the electrical installation must include suita-

ble means of isolating the appliance from the mains (e.g. fuse, cut-out, current trip or similar with a

minimum contact separation of 3 mm).

Before initial start-up, refer to the appliance serial plate to ascertain if supply voltage and current values

correspond with those of the mains at the installation location.

e.g.:

AC 220 ... 240 V 50 Hz or

(i.e. 220 to 240 volts alternating current, 50 Hertz)

The rating plate is inside the appliance on the left.

220 ... 240 V ~50 Hz

Table of Contents