Table of Contents
Advertisement
Malfunction
Appliance does not work.
Appliance cools too much.
The food is too warm.
Interior lighting does not work.
Heavy build up of frost, possibly also
on the door seal.
Unusual noises.
Water on the floor or on storage
shelves.
The compressor does not start imme-
diately after changing the tempera-
ture setting.
Possible Cause
Appliance is not switched on.
Mains plug is not plugged in or is
loose.
Fuse has blown or is defective.
Socket is defective.
Temperature is set too cold.
Temperature is not properly adjusted. Please look in the "Initial Start Up" section.
Door was open for an extended peri-
od.
A large quantity of warm food was
placed in the appliance within the
last 24 hours.
The appliance is near a heat source.
Light bulb is defective.
Door seal is not air tight (possibly
after changing over the hinges).
Appliance is not level.
The appliance is touching the wall or
other objects.
A component, e.g. a pipe, on the rear
of the appliance is touching another
part of the appliance or the wall.
Water drain hole is blocked.
This is normal, no error has occurred. The compressor starts after a period of time.
Remedy
Switch on the appliance.
Insert mains plug.
Check fuse, replace if necessary.
Mains malfunctions are to be corrected by an
electrician.
Turn the temperature regulator to a warmer
setting temporarily.
Open the door only as long as necessary.
Turn the temperature regulator to a colder set-
ting temporarily.
Please look in the "Installation location"section.
Please look in the "Changing the Light Bulb".
Carefully warm the leaking sections of the door
seal with a hair dryer (not hotter than approx.
50 °C).
At the same time shape the warmed door seal
by hand such that it sits correctly.
Readjust the feet.
Move the appliance slightly.
If necessary, carefully bend the component out
of the way.
See the "Cleaning and Care" section.
55
Advertisement
Table of Contents
