Mitsubishi Electric MELSEC-Q Series User Manual page 263

[H]
Handling precautions ...................................... 4-1
Hold command ............................................ 3-103
Hold status flag............................................ 3-106
[I]
I/O signals...................................................... 3-57
Indication accuracy ......................................... 3-4
Input range ................................................... 3-82
Input sensor .................................................... 3-3
Integral action (I-action) .................................. 1-9
Intelligent function module switch setting ....... 4-8
Internal current consumption .......................... 3-2
[L]
Loop disconnection detection dead band
....................................................................... 3-96
Loop disconnection detection function ......... 3-15
Loop disconnection detection judgment time
....................................................................... 3-96
[M]
MAN output setting........................................ 3-93
Manipulated value (MV) ................................ 3-78
Measured value (PV) .................................... 3-77
Module ready flag (Xn3)................................ 3-59
[O]
Online module change .................................... 7-1
Operation at input disconnection .................... 3-5
Output variation limiter .................................. 3-88
[P]
Parameter change in program control function
....................................................................... 3-49
Part names ...................................................... 4-3
Pattern end output flag................................ 3-106
Performance specifications............................. 3-1
PID action ...................................................... 1-11
PID constant setting ...................................... 3-85
PID constant read command from FeRAM...3-97
PID constant read/write completion flag from
FeRAM................................................3-80
PID control system .......................................... 1-5
PID continuation flag .................................... 3-99
PID operation................................................... 1-6
Primary delay digital filter setting .................. 3-90
Procedures before operation .......................... 4-2
Index - 2
Program control function ...............................3-24
Program control run/reset..............................3-95
Program pattern ...........................................3-111
Pattern end output time of program
pattern ......................................................3-113
Program pattern final segment ................3-111
Program pattern iteration .........................3-112
Program pattern link setting.....................3-111
Segment set value (SV) setting ...............3-114
Segment time scale .................................3-114
Segment Zone PID data No ....................3-114
Wait zone setting of program pattern ......3-113
Programming ...................................................6-1
Proportional action (P-action)..........................1-8
[Q]
Q62HLC control status controlling output
signal and buffer memory settings and
control status..................................................3-52
[R]
Reverse/forward action select function .........3-13
RFB limiter function .......................................3-13
[S]
Sampling period .............................................3-56
Scaling function..............................................3-39
Scaling range upper/lower limit value .........3-102
Scaling value ...............................................3-101
Scaling width upper/lower limit value ..........3-102
Segment monitor..........................................3-105
Segment remaining time..............................3-105
Sensor compensation value setting ..............3-88
Set value (SV) setting ....................................3-84
Set value at program control start (SV_PCS)
setting...........................................................3-115
Set value monitor ...........................................3-78
Setting change command (YnB) ...................3-64
Setting change completion flag (XnB) ..........3-61
Setting change rate limiter ............................3-93
Setting/operation mode command
(Yn1)...............................................................3-62
Setting/operation mode status (Xn1) ............3-58
Simplified analog I/O function........................3-48
Start mode....................................................3-108
Stop mode setting..........................................3-84
Ind
Index - 2