Installing And Uninstalling The Utility Package; Handling Precautions - Mitsubishi Electric MELSEC-Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-TC)

5.2 Installing and Uninstalling the Utility Package

5.2.1 Handling precautions

5 - 4
For how to install or uninstall the utility package, refer to "Method of installing the
MELSOFT Series" included in the utility package.
The following explains the precautions on using the utility package.
(1) For safety
Since the utility package is add-in software for GX Developer, read "SAFETY
PRECATIONS" and the basic operating procedures in the GX Developer
Operating Manual.
(2) About installation
GX Configurator-TC is add-in software for GX Developer Version 4 or later.
Therefore, GX Configurator-TC must be installed on the personal computer that
has already GX Developer Version 4 or later installed.
(3) Screen error of the intelligent function module utility
Insufficient system resource may cause the screen to be displayed
inappropriately while using the intelligent function module utility.
If this occurs, close the intelligent function module utility, GX Developer (such as
a program and comment), and other applications, and then start GX Developer
and the intelligent function module utility again.
(4) To start the intelligent function module utility
(a) In GX Developer, select "QCPU (Q mode)" for PLC series and specify a
project. If any PLC series other than "QCPU (Q mode)" is selected, or if no
project is specified, the intelligent function module utility will not start.
(b) Multiple intelligent function module utilities can be started.
However, [Open parameters] and [Save parameters] operations under
[Intelligent function module parameter] are allowed for one Intelligent
function module utility only. Only the [Monitor/test] operation is allowed for
the other utilities.
(5) Switching between two or more Intelligent function module utility
windows
When two or more Intelligent function module utility windows cannot be displayed
side by side, select a screen to be displayed on the top of others using the task
bar.
MELSEC-Q
5 - 4