Mitsubishi Electric MELSEC-A Series Manual page 83

2
REPLACEMENT OF MELSECNET (II) AND /B (PLC TO PLC NETWORK)
Network parameter setting is required for control and normal stations on MELSECNET/H.
The following shows parameters required on each station of MELSECNET/H.
Common parameter
(Network range
assignment)
1Mp3
(Refer to example in (e) 2))
1Ns2
1Ns1
2Mp3
(Refer to example in (g) 2))
2Ns1
2Ns2
Station inherent parameter
(Refer to example in (e) 3)) (Refer to example in (e) 4))
(Refer to example in (f) 2)) (Refer to example in (f) 3))
-
(Refer to example in (g) 3))
-
(Refer to example in (g) 4))
(Refer to example in (h) 2)) (Refer to example in (h) 3))
(Refer to example in (h) 2)) (Refer to example in (h) 3))
: Setting required/ : Setting required (Default setting is also acceptable)/ - Setting not required
Refresh parameter Inter-link data transfer
(Refer to example in (g) 5))
2
- 46