Installation; Right Place For Installation; Attaching The Plastic Wedges; Adjusting The Stands - Blomberg KFD4952XD User Manual

3

Installation

3.1. Right place for installation

To ready the product for installation, see the
information in the user guide and make sure the
electric and water utilities are as required. If not, call
an electrician and plumber to arrange the utilities as
necessary.
WARNING:
B
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
WARNING:
B
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
WARNING
A
narrow for the product to pass, remove
the door and turn the product sideways; if
this does not work, contact the authorized
service.
• Place the product on a flat surface to avoid
vibration.
• Place the product at least 30 cm away from the
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
• Do not expose the product to direct sunlight or
keep in damp environments.
• The product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
• Do not install the product in environments with
temperatures below -5°C.
3.2. Attaching the
plastic wedges
Use the plastic wedges provided with the product
to provide sufficient space for air circulation
between the product and the wall.
1. To attach the wedges, remove the screws on the
product and use the screws provided with the
wedges.
Refrigerator / User Manual
The manufacturer assumes
The product's power cable
: If the door span is too
2. Attach 2 plastic wedges on the ventilation cover
as shown in the figure.

3.3. Adjusting the stands

If the product is not in balanced position, adjust the
front adjustable stands by rotating right or left.
7 / 38 EN