Sony HDS-7150 Installation Manual page 3

Attention-when the product is installed in Rack:
1. Prevention against overloading of branch circuit
When this product is installed in a rack and is
supplied power from an outlet on the rack, please
make sure that the rack does not overload the supply
circuit.
2. Providing protective earth
When this product is installed in a rack and is
supplied power from an outlet on the rack, please
confirm that the outlet is provided with a suitable
protective earth connection.
3. Internal air ambient temperature of the rack
When this product is installed in a rack, please make
sure that the internal air ambient temperature of the
rack is within the specified limit of this product.
4. Prevention against achieving hazardous
condition due to uneven mechanical loading
When this product is installed in a rack, please make
sure that the rack does not achieve hazardous
condition due to uneven mechanical loading.
HDS-7150/7100
WARNING (For HKDS-7695A)
THIS APPARATUS MUST BE EARTHED.
a) An equipment grounding conductor that is not
smaller in size than the ungrounded branch
circuit supply conductor, is to be installed as part
of the branch circuit that supplies the equipment.
Bare, covered or insulated grounding conductors
are acceptable. Individually covered or insulated
equipment grounding conductors shall have a
continuous outer finish that is either green, or
green with one or more yellow stripes.
The equipment grounding conductor is to be
connected to ground at the service equipment.
b) The attachment plug receptacles in the vicinity of
the equipment are all to be of a grounding type,
and the equipment grounding conductors serving
these receptacles are to be connected to earth
ground at the service equipment.
1 (P)