Sony HDS-7150 Installation Manual page 20

HDS-7150/7100
2-2. Rack Mounting
(4) Temporarily secure the bracket and the plate nut (long) to the outer member 1 by the preparated
screws (B4 x 8) for fixing the plate nut (long). While sliding the outer member 2 back-and-forth, to
see the screw hole of the outer member 1, attach the bracket and the plate nut (long).
Plate nut (long)
Outer member 2
(5) Temporarily secure the each outer member assembly (bracket) to both sides of the rack by the two
screws (C4 x 12), the two washers (W4), and the plate nut (short) supplied with the RMM-18DV.
Adjust the installation position of the outer member assembly to meet the specification shown in the
figure.
After the adjustment, tighten the screws (B4 x 8) temporarily secured in the step (4).
Plate nut (short)
Rack
C4 x 12
W4
2-4
Plate nut (long)
Brackets
B4 x 8
B4 x 8
Outer member stopper
(Used for fixing the outer member 2.)
Outer member
assembly
C4 x 12
Bracket
12.7
44.45
Outer member 1
B4 x 8
B4 x 8
TOP VIEW
Rack
Bracket
W4
Spec
Outer member 1
5
+
50
0
_
Plate nut (short)
Unit : mm
HDS-7150/7100