Pre-Maintenance Procedures
Pre-Maintenance Safety
•
Before adjusting, cleaning, repairing, or leaving
the machine, do the following:
– Move the machine on a level surface.
– Shut off the engine and remove the key.
– Set the battery-disconnect switch to the
position.
– Wait for all moving parts to stop.
Accessing Internal Components
Opening the Front and Rear Hoods
Use 1 key to unlock the latch and push the lever open.
Use the smaller key to unlatch the hood.
– Allow machine components to cool before
performing maintenance.
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Use adequate support to support the machine or
components when required.
OFF
•
Carefully release pressure from components with
stored energy.
Figure 74
67
g218949