Table of Contents
Advertisement
3.
Place a block at the front and rear of the trailer
and/or truck tires.
4.
Using the travel pendant, set the engine and the
tram speed to slow.
5.
Using the travel pendant, carefully tram the
machine forward or rearward up the ramp and
into position on the trailer.
6.
Lower the stake-down tube to the deck of the
trailer.
1. Tie-down points (only left side shown)
10.
Measure the distance from the ground to the
highest point on the machine for reference to
ensure that you do not collide with low hanging
obstacles.
11.
Remove the block from the trailer tires, and stow
them with the machine for use when unloading it.
12.
After tramming a few miles, pull over and check
to ensure that all chains are still tight and that
the machine has not moved.
To unload the machine, reverse the above procedure.
7.
Lower the stabilizers until the stabilizer feet
contact the trailer floor.
8.
Turn off the engine.
9.
Use appropriately rated chains and binders
to secure the rings on the left and right track
frames and through the tube on the stake-down
plate to the trailer
Figure 53
49
(Figure
53).
g239626
Advertisement
Table of Contents
