Table of Contents
Advertisement
Right Joystick
The joystick controls vary depending on the control mode you select when powering up the machine. There are
2 control modes: Drill Mode I and Drill Mode II; refer to the Control-Select Screen in the Software Guide for
information on setting the control modes.
1. Turn the mud on or off
2. Increase the mud flow momentarily
3. Decease the mud flow momentarily
Right Joystick — Drill Mode I
Figure 34
Right Joystick — Drill Mode I
1. Thrust the carriage forward 3. Pull the carriage back
2. Rotate the drill spindle
counter clockwise
Right Joystick
4. Open and Close the rear wrench
5. Open and close the front wrench
6. Rotate the wrench clockwise and
counter clockwise (make and break
rotation)
g226144
4. Rotate the drill spindle
clockwise
Figure 33
Right Joystick — Drill Mode II
Right Joystick — Drill Mode II
1. Thrust the carriage forward 3. Pull the carriage back
2. No action
32
7. Set the auto drill on or off
8. Set the carriage to high speed
9. Max flow of mud
Figure 35
4. No action
g226146
g226144
Advertisement
Table of Contents
