Removing And Installing The Inner-Wing-Deck Covers - Toro Groundsmaster 5900 Operator's Manual

Removing and Installing the
Inner-Wing-Deck Covers
Removing the Inner-Wing-Deck
Covers
1. Lower the wing deck onto a level surface.
2. Disengage the cover latch.
3. Remove the bolt securing the belt cover (if
equipped).
4. Lift the rear and inside cover edges off the
mounting posts (Figure
Figure 77
1. Mounting posts
5. While lifting the cover, slide it toward the traction
unit approximately 2.5 cm (1 inch) to disengage
the outer-cover edge from the deck
Figure 78
1. Slide the cover inward
approximately 2.5 cm (1
inch).
6. Lift the front edge and guide it between the lift
arm and the roller to remove it
77).
g013892
(Figure 78).
g013893
2. Disengage these cover
edges.
(Figure 79).
1. Slide the cover out between the lift arm and roller.
Installing the Inner-Wing-Deck
Covers
1. Lower the wing deck onto a level surface.
2. Slide the cover into position by guiding the rear
edge between the lift arm and the roller.
3. While sliding the cover away from the traction
unit, guide the outside edge under the front and
rear brackets on the deck.
4. Align the deck mounting posts with the holes in
the cover and lower the cover into position.
5. Install the bolt securing the belt cover (if
equipped).
6. Engage the deck-cover latch.
64
Figure 79
g013894