Raising The Machine; Removing And Installing The Inner-Wing-Deck Covers - Toro Groundsmaster 5900 Operator's Manual

Raising the Machine

Use the following as points to jack up the machine:
Front of the machine—on the frame, on the inside of
each drive tire (Figure
Figure 81
1. Front jacking point (2)
Rear of the machine—at the center of the axle
(Figure 82)
Figure 82
1. Rear jacking point
81)
Removing and Installing the
Inner-Wing-Deck Covers
Removing the Inner-Wing-Deck
Covers
1. Lower the wing deck onto a level surface.
2. Disengage the cover latch.
3. Remove the bolt securing the belt cover (if
equipped).
4. Lift the rear and inside cover edges off the
mounting posts
g008996
1. Mounting posts
5. While lifting the cover, slide it toward the traction
unit approximately 2.5 cm (1 inch), to disengage
the outer cover edge from the deck
g008995
1. Slide the cover inward
approximately 2.5 cm (1
inch).
6. Lift the front edge and guide it between the lift
arm and the roller to remove it
65
(Figure 83).
Figure 83
(Figure
Figure 84
2. Disengage these cover
edges.
(Figure
g013892
84).
g013893
85).