Adding Fuel
1.
Park the machine on a level surface
2.
Shut off the engine, remove the key, and engage
the parking brake.
3.
Clean around the fuel-tank cap and remove the
cap.
4.
Add fuel and install the fuel-tank cap. Wipe up
any spilled fuel.
Figure 16
Checking the Tire Pressure
(Figure
16).
Service Interval: Before each use or daily
The correct air pressure in the front tires is 220 kPa
(32 psi) and the rear tires is 207 kPa (30 psi) as
shown in
Important:
ensure a good quality of cut and proper machine
performance. Do not underinflate the tires.
Check the air pressure in all the tires before
operating the machine.
Traction performance, including tire-slip control,
is dependent on the ratio of the tire size between
the front and rear tires. Use only genuine Toro
tires.
Checking the Caster Wheel
Tire Pressure
The correct air pressure in the caster wheel tires is
340 kPa (50 psi).
Important:
ensure a good quality of cut and proper machine
performance. Do not underinflate the tires.
Check the air pressure in all the tires before
operating the machine.
g031226
Checking the Torque of the
Wheel-Lug Nuts
Service Interval: After the first 10 hours
Every 250 hours
29
Figure
17.
Maintain pressure in all tires to
Figure 17
Maintain pressure in all tires to
g001055