Installing The Batteries; Drive System Maintenance; Calibrating The Traction Pedal; Adjusting The Traction-Pedal Angle - Toro Groundsmaster 5900 Operator's Manual

Installing the Batteries

1. Secure the batteries with the hold downs
113).
2. Install the battery cables.
3. Position the battery cover in place and secure it
with the removed fasteners.
4. Install the rear shroud
5. Install the side shrouds
6. Raise the rear bumper into position and install
the flange screws. Tighten all the flange screws
securing the rear bumper to the frame
110).
7. Turn the battery-disconnect switch to the O
position.
(Figure
(Figure 112).
(Figure 111).
(Figure
N
Drive System
Maintenance
Calibrating the Traction
Pedal
Service Interval: Every 1,000 hours—Calibrate the
traction pedal.
Contact your autorized Toro distributor or refer to the
Toro Service Manual for assistance.
Adjusting the
Traction-Pedal Angle
You can adjust the operating angle of the traction
pedal for your comfort.
1. Loosen the 2 nuts and bolts securing the left side
of the traction pedal to the bracket
1. Traction pedal
2. Pivot the pedal to the desired operating angle
and tighten the nuts
79
(Figure
Figure 114
2. Mounting nuts and bolts
(Figure 114).
114).
g009745