Preparing The Machine For Maintenance; Raising The Machine; Removing And Installing The Inner-Wing-Deck Covers - Toro 31598 Operator's Manual

•
Carefully release pressure from components with stored
energy.
•
If your machine requires major repairs or if you desire
assistance, contact an Authorized Toro Distributor.
•
Use only genuine Toro replacement parts and accessories.
Replacement parts and accessories made by other
manufacturers could be dangerous, and such use could
void the product warranty.
Preparing the Machine for
Maintenance
1. Ensure that the PTO is disengaged.
2. Park the machine on a level surface.
3. Set the parking brake.
4. Lower the cutting unit(s) if necessary.
5. Shut off the engine and wait for all moving parts to
stop.
6. Turn the ignition key to the S
it.
7. Allow machine components to cool before performing
maintenance.

Raising the Machine

Use the following as points to jack up the machine:
Front of the machine—on the frame, on the inside of each
drive tire (Figure 43)
1. Front jacking point (2)
Rear of the machine—at the center of the axle
position and remove
TOP
Figure 43
(Figure
1. Rear jacking point
Removing and Installing the
Inner-Wing-Deck Covers
Removing the Inner-Wing-Deck Covers
1. Lower the wing deck onto a level surface.
2. Disengage the cover latch.
3. Remove the bolt securing the belt cover (if equipped).
4. Lift the rear and inside cover edges off the mounting
posts (Figure
1. Mounting posts
5. While lifting the cover, slide it toward the traction unit
approximately 2.5 cm (1 inch), to disengage the outer
cover edge from the deck
44)
38
Figure 44
45).
Figure 45
(Figure 46).