Toro Groundsmaster 5900 Operator's Manual page 23

Throttle Switch
The throttle switch has 2 positions:
(Figure 11).
IDLE
Press the switch forward for 2 or more seconds to set
the throttle at H I
IGH DLE
for 2 or more seconds to set the throttle at L
or momentarily press the switch in either direction to
increase or decrease the engine speed in 100-rpm
increments.
Light Switch
Press the light switch upward to turn the lights to the
O position (Figure 11).
N
Press the light switch downward to turn the lights to
the O position.
FF
Horn Button
Press the horn button to activate the horn
Seat Adjustments
Seat-Adjustment Lever
Move the seat-adjustment lever on the side of the
seat outward, slide the seat to the desired position,
and release the lever to lock the seat into position
(Figure 12).
Figure 12
1. Weight gauge
2. Weight-adjustment lever
3. Seat-adjustment lever
Armrest-Adjustment Knob
Rotate the knob to adjust the armrest angle
12).
and
LOW IDLE
; press the switch rearward
OW
(Figure
4. Seat-back adjustment
lever
5. Armrest-adjustment knob
(Figure
Seat-Back-Adjustment Lever
Move the lever to adjust the seat-back angle
HIGH
12).
Weight Gauge
I ;
DLE
The weight gauge indicates when the seat is adjusted
to the weight of the operator
height by positioning the suspension within the range
of the green region.
Weight-Adjustment Lever
Use this lever to adjust to the proper weight of the
operator (Figure
the air pressure and push down to decrease the air
pressure. The proper adjustment is correct when the
weight gauge is in the green region.
USB Power
11).
You can insert your portable charger into the USB
ports to charge a personal device, such as a phone or
other electronic device
Audible Alarm (Console)
The alarm is activated when a fault is detected.
The buzzer sounds when the following occur:
•
The engine sends a stop fault
•
The engine sends a check-engine fault
•
The fuel level is low
g024916
23
(Figure 12). Adjust the
12). Pull up the lever to increase
(Figure 11).
(Figure