Table of Contents
Advertisement
Troubleshooting
Condition
The machine is not
picking up debris.
The machine has
excessive vibration.
The diagnostic light on
the machine does not
illuminate when pressing
a remote button.
Checking Fault Codes
If the diagnostic light indicates that there is a system fault (refer to
codes to determine what is wrong with the machine.
Possible Causes
The brush is damaged.
The brush height is too high.
The front flap height is too low or too high.
Check the bearings on the brush shaft. If they are
excessively hot, check the bearings for damage.
Foreign materials are wrapped around brush.
There is frequency interference.
Replace the brush.
Adjust the brush height; refer to
Height (page
Adjust the front flap height; refer to
Front Flap Height (page
Replace any damaged bearings.
Clean off any foreign objects.
Associate the remote control to the base unit; refer
to
Associating the Remote Control and the Base
Unit (page
Diagnostic Light (page
34
Corrective Action
Adjusting the Brush
21).
Adjusting the
23).
32).
19), check the fault
Advertisement
Table of Contents
