Troubleshooting - Toro 23740 Operator's Manual

Troubleshooting

Problem
The engine will not start, starts hard, or
fails to keep running.
The engine loses power.
The broom does not clean the surface.
The broom does not rotate.
The machine pulls left or right.
The machine does not drive.
There is abnormal vibration.
The broom does not stop when the drive
lever is released.
Possible Cause
1. The fuel tank is empty.
2. The fuel-shutoff valve is closed.
3. The throttle and choke are not in the
correct position.
4. There is dirt in fuel valve.
5. The fuel cap vent is blocked.
6. Dirt, water, or stale fuel is in the fuel
system.
7. The air cleaner is dirty.
8. The spark plug is faulty.
9. The spark-plug wire is not connected.
1. The engine load is excessive.
2. The air cleaner is dirty.
3. The oil level in the crankcase is
incorrect.
4. There is dirt in fuel tank filter.
5. Dirt, water, or stale fuel is in the fuel
system.
1. The broom height is incorrect .
2. The tire pressure in the drive tires is
not correct.
3. You are cleaning too much debris at
one time.
1. The broom is clogged.
2. The broom drive lever is not engaged.
3. The broom drive belt is slipping.
4. The belt is broken.
5. The shear pin is broken.
1. The tire pressure in the drive tires is
not correct.
1. The drive belt is worn, loose or broken.
2. The drive belt is off a pulley.
1. The broom assembly is loose or
damaged.
2. The engine mounting bolts are loose.
3. The engine pulley or idler pulley is
loose.
4. The engine pulley is damaged.
5. The belt is damaged.
1. The broom-drive belt is out of
adjustment.
28
Corrective Action
1. Fill the fuel tank.
2. Open the fuel-shutoff valve.
3. Be sure the throttle control is midway
between the Slow and Fast positions,
and the choke is in the On position for
a cold engine or the Off position for a
warm engine.
4. Clean the fuel-valve screen and cup.
5. Clean the fuel-cap vent.
6. Contact an authorized engine service
dealer.
7. Clean or replace the air cleaner
element.
8. Clean, adjust or replace the spark plug.
9. Check the spark-plug wire connection.
1. Reduce the ground speed or adjust the
broom.
2. Clean or replace the air cleaner
element.
3. Check the oil level in the crankcase.
4. Clean the fuel-tank filter.
5. Contact an authorized engine service
dealer.
1. Adjust the broom height.
2. Adjust the tire pressure in the drive
tires.
3. Slow down and clear smaller areas of
debris.
1. Unclog the broom.
2. Engage the broom drive lever.
3. Adjust or replace the belt.
4. Replace the belt.
5. Replace the shear pin.
1. Adjust the tire pressure in the drive
tires.
1. Install a new belt.
2. Replace or adjust the belt.
1. Tighten the hardware, replace the
broom assembly, or contact an
Authorized Toro Service dealer.
2. Tighten the engine-mounting bolts.
3. Tighten the appropriate pulley.
4. Contact an Authorized Toro Service
dealer.
5. Install a new belt.
1. Check the broom-drive adjustment.