Table of Contents
Advertisement
Associating the Remote
Control and the Base Unit
Important:
Read the entire procedure before
performing the procedure.
The remote control must establish communications
with the base unit before you can use the system.
The remote control is associated to the system
base unit before leaving the factory using the
associate procedure. In situations where it is
necessary to re-establish remote control-to-base
unit communications (e.g., introducing a new or
spare remote control to an existing base unit), do the
following.
Note:
Associating the remote control to a different
base unit disassociates that remote control from the
original base unit.
1.
Remove power from the base unit.
2.
Stand near the base unit in unobstructed, clear
line-of-sight with the remote control in hand.
3.
Simultaneously press and hold the
and
OFFSET RIGHT
about once per second.
4.
Continue to hold both buttons until the LED
begins blinking about twice per second.
5.
Release the buttons.
6.
Press and hold the
LED blinks about twice per second.
7.
Continue holding the
turn the key start to the R
turns solid if the procedure is successful.
Note:
This could take up to 20 seconds.
8.
Release the
OFFSET LEFT
The system is ready for use with that particular
remote control.
OFFSET LEFT
buttons. The LED blinks
button. The
OFFSET LEFT
button and
OFFSET LEFT
position. The LED
UN
button.
1. LED light
2. Offset left
3. Sweeper down
4. Hopper dump
32
Figure 39
5. Stop
6. Sweeper up
7. Offset right
g030468
Advertisement
Table of Contents
