Table of Contents
Advertisement
Figure 29
CAUTION
Dumping the hopper can injure
bystanders or pets.
While dumping, keep bystanders and
pets away from the hopper.
Lowering the Hopper
To lower the hopper, press the sweeper down button.
Note:
Ensure that the hopper is in the down position
before you start to tow the machine.
Operating the Machine in
Cold Weather
The hydraulic fluid in the machine must reach an
operating temperature of 82°C (180°F) for proper
operation of the floating machine head.
Switching the Sweeper-Up
Mode
The Sweeper-Up button has 2 possible modes:
standard and optional.
The standard mode allows you to raise the machine
to the pre-defined heights. Refer to
Button—Standard Mode (page 18)
The optional mode allows you to adjust the machine
to any desired height and it stops at the pre-defined
heights. Refer to
Sweeper Up Button—Optional Mode
(page
18).
1.
Remove the cover off the control module.
2.
Unplug the 2 wire connections from the pigtail
connector shown in
3.
Plug the 2 wire connections into the existing
pigtail connector tethered to the wire harness.
4.
Install the cover onto the control module.
Sweeper Up
Figure
30.
g030465
1. Location of pigtails
2. Optional-mode pigtail
(tethered to the wire
harness)
Note:
To return to standard mode, install the
original pigtail connector.
After Operation
After Operation Safety
•
Park the tow vehicle on a level surface; engage
the parking brake of the tow vehicle; shut off the
engine; remove the key; and wait for all movement
to stop before leaving the operator's position.
•
Allow the machine to cool before storing the
machine in any enclosure.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn, damaged, or missing decals.
Inspecting and Cleaning
the Machine
When sweeping has been completed, thoroughly
clean the machine. Air dry the hopper. After
27
Figure 30
3. Standard-mode pigtail
g030597
Advertisement
Table of Contents
