Table of Contents
Advertisement
11
Assembling the Handheld
Remote
Parts needed for this procedure:
1
Handheld remote
4
Battery (AAA)
6
Small screws
Procedure
1.
Remove the rubber bands securing the remote
halves together, and remove the back cover.
2.
Plug each battery into a terminal cradle,
observing proper polarity
Note:
If you install the batteries improperly, the
machine will not be damaged, but it will fail to
operate. The cradle is embossed with polarity
markings for each terminal.
Figure 17
1. Screw
2. Cover
3. Seal
3.
Ensure that the steel gasket and rubber seal are
seated in the channel in the remote and set the
back cover in place
4.
Secure the cover with 6 screws
torque them to 1.5 to 1.7 N∙m (13 to 15 in-lb).
Note:
Do not overtighten the screws.
(Figure
17).
4. Steel gasket
5. Batteries
6. Handheld remote
(Figure
17).
(Figure
17) and
g029817
17
Advertisement
Table of Contents
