Table of Contents
Advertisement
Adjusting the Roller
Scraper
Check and ensure that the roller scraper
adjusted with a 2 mm (1/16 inch) clearance between
the scraper and the roller. Loosen the roller scraper
adjusting nuts, position the roller as desired, and
tighten the nuts.
Adjusting the Front Flap
Height
For best debris pickup results, adjust the front flap
(Figure
22) with a 6 mm to 13 mm (1/4 inch to 1/2 inch)
clearance between the bottom of the flap and surface.
Note:
You may need to raise the front flap all the way
or remove the front flap when picking up larger debris
or picking up debris in long grass.
Figure 22
1. Front flap
1.
Loosen the nuts securing the metal strap and
the front flap to the brush housing
Figure 23
1. Front flap
2.
Adjust the front flap to the desired operating
height and tighten the nuts.
(Figure
21) is
g011014
(Figure
23).
g011015
2. Metal strap
Checking the Tire Pressure
Check the tire pressure daily to ensure that they are
inflated properly.
Correct tire air pressure: 86.2 kPa (12.5 psi)
Maximum tire air presssure: 124 kPa (18 psi)
Checking the Wheel Lug
Nut Torque
WARNING
Failure to maintain proper torque could result
in failure or loss of wheel and could result in
personal injury.
Ensure that the wheel lug nuts are tightened
to the appropriate torque.
Check and torque the wheel lug nuts to 95 to 122 N∙m
(70 to 90 ft-lb).
1. Lug nut
Activating the Controller
The controller
(Figure
plug the machine harness into the tow vehicle power
harness.
23
Figure 24
25) is activated as soon as you
g292670
Advertisement
Table of Contents
