Table of Contents
Advertisement
1. Open notches
2. Brush length
3. Center brush shaft height
1.
Move the machine to a level surface.
2.
Raise the hopper and install the hopper safety support. Refer to
(page
24).
3.
Loosen the locknut on the height adjustment key
13 mm (1/2 inch).
1. Locknut
2. Height-adjusting key tab
3. Roller-height adjusting nuts
4.
Loosen the roller-height adjustment locknuts
5.
Pull out the height-adjusting key and move the rear roller up or down by sliding the roller-height adjusting
plate to the desired height
6.
Tighten the locknuts to secure the adjustment.
7.
Repeat the procedure on the opposite end of the brush; ensure that the adjustments are the same.
Figure 20
Figure 21
(Figure
(Figure
21).
22
4. 6 to 13 mm (1/4 to 1/2 inch)
5. Brush direction
Using the Hopper Safety Support
(Figure
21) so that you can pull it out approximately
4. Roller-height adjusting plate
5. Roller-scraper adjusting nuts
21).
g011012
g011013
Advertisement
Table of Contents
