Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1. Move the machine onto a level surface, set the parking
brake, shut off the pump, shut off the engine, and
remove the ignition key.
2. Unlatch the seat by pushing the seat-latch handle
rearward
(Figure
2).
1. Seat
2. Prop rod
3. Rotate the seat and seat plate forward until the end of
the prop rod at the prop-rod bracket is at the bottom
of the groove of the bracket
4. Disconnect the battery by removing the bolt and nut
that secures the terminal of the positive-battery cable
to the positive post of the battery.
Note: Ensure that the terminal of the battery cable
does not touch the post.
Figure 2
3. Seat-latch handle
(Figure
2).
1. Nut
2. Battery post
2
Removing the Seat
No Parts Required
Procedure
1. Remove the electrical connector of the chassis harness
that connects to the seat-switch connector
1. Connector (chassis
harness)
2. Remove the hairpin that secures the prop rod to the
bracket at the bottom of the seat plate
4
Figure 3
3. Terminal (positive-battery
cable)
4. Bolt
(Figure
Figure 4
2. Seat-switch connector
(Figure
4).
5).
Advertisement
Table of Contents
